Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 HP 9000 Computers Edition 1

64 Chapter 3
Installing From Media
Booting the Target System
2. Press any key to stop the autoboot process, at the message to do so.
3. Insert the install media (tape or CD-ROM).
4. Determine the hardware path of the install device from your system
administrator. (There is no search capability to determine this
information on older HP 9000 Server models).
• If the primary path shown on your screen is not the same as that
for the install device, respond with "n" to the prompt "Boot from
primary boot path". In this case, you will then be asked if you
want to boot from the alternate path, which is typically set to the
tape or CD-ROM device.
• If the primary path shown on your screen matches that for the
install device, respond with "y".
• If neither the primary or alternate device paths correspond to that
for the tape or CD-ROM device, then respond with "n" to both
prompts. In this case, enter the hardware path of the device (for
example, 52.3.0) at the prompt "Enter boot path, command,
or ?>".
5. To the question "Interact with IPL (y or n)?", respond with
"n".
After Selecting Boot Paths (Workstation and Server)
• If you see the following question on your screen, type n:
Interact with IPL (Y or N)?> n
• You can abort the installation at this point, if you wish, by turning
the system off and starting over.
• When you have chosen the boot path and loaded the Ignite-UX utility,
the system will display the Ignite-UX keyboard languages screen, if
your target system has a PC-style keyboard. From this point on, you
can respond to the requests for information on this and the following
screens.
Time Note: Loading the Install Kernel should take 3 to 5 minutes.