Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 HP 9000 Computers Edition 1

Chapter 4 93

Conﬁguring an Ignite-UX Server

Setting Up an Ignite-UX Server

Figure 4-2

The Server Options

Tab

• Select on Default Conﬁgurations, highlight the one you want to use

from the list. When doing a client installation, this conﬁguration will

be installed on targets if no other is speciﬁed. (The default setting can

be overridden on a per-client basis by Ignite-UX).

• Click on the selection list to display the available (conﬁgured)

printers. Select the one you want to use.

If necessary, use the SAM → Printers and Plotters area to conﬁgure a

new printer onto the system.

This will be the printer for printing the manifest or installation

history. The printer address will be checked by Ignite-UX before a job

is sent.

• Select the appropriate Client Timeout time, or "Off", to set the time

limit for the client to be connected without responding. (This will set a

limit on the time since the client install log has been written in.

Fifteen to thirty minutes may be required at some points in the

installation.) A warning note will be displayed if this time is

exceeded.

Setting Client Timeout to "off" disables this notiﬁcation.