HP Instant Capacity User's Guide for versions B.07.x

Installing and Uninstalling Instant Capacity Software
Installing Instant Capacity Software
Chapter 346
For All Installations
After you have successfully installed the Instant Capacity B.07.x
software using the swinstall command, perform the following
procedure to validate your installation:
Step 1. Execute the command: /usr/sbin/icod_stat
Step 2. Verify that the icod_stat command’s output indicates the correct
number of licensed and unlicensed components for cells, processors, and
memory.
If any number is incorrect, contact the Instant Capacity administrator at
the following e-mail address:
[e-mail]
Step 3. Log in as root
Step 4. Set the system-contact information by entering the following command:
/usr/sbin/icod_modify -c
<contact_email_address>
Step 5. If you wish to configure asset reporting, then ensure that outgoing mail
can be sent to HP mail servers from your system, even if the system is
behind a firewall. See “Diagnosing E-mail Configuration” on page 111.
• Test the transmission of your asset report, via e-mail to HP, by
entering the following command:
/usr/sbin/icod_notify
<reply_address>
The icod_notify command sends an asset report to HP, root, and
the supplied reply address.
HP responds with a reply e-mail to the reply address after the asset
report is received.
• Use an e-mail client to verify the return e-mail from HP to the reply
e-mail address