ACC Installation and Configuration Guide

Chapter 2 37
Software Installation and Verification
Hardware Installation
Hardware Installation
Install the ACC Mux card or cards on your HP 9000 computer according
to the instructions in the appropriate ACC Multiplexer Hardware
Installation and Reference Manual. We hi ghly recommend that you
install the hardware b efore the ACC software is installed. The ACC
installation process creates ttgen configuration files based on the actual
locations of installed ACC Mux cards.
NOTE If the system will only run application programs using the ZCOM
application interface to access ACC Mux cards on remote systems, you do
not need to install any ACC Interface cards on your local system.
T1/E1 Interfaces
The Z7300A ACC Mux card supports several different T1/E1 interfaces.
Each of these interfaces has a different physical connector and different
line termination. For this reason, the interface card is shipped with a kit
of plug-in resistor modules (SIPs). Select and install the appropriate
resistor pack to correspond with the desired interface configuration.
Adding or Moving Mux Cards
If any ACC interface cards are added to the system or moved within the
system after the ACC base product is installed, the sample loopback
configurationfilewillneedtobeupdated.See“AddingorMoving
Hardware After Installation” on page 40 for detailed information.