ACC Installation and Configuration Guide

38 Chapter2
Software Installation and Verification
Software Installation
Software Ins ta llation
Read the ACC software from the installation media, in superuser mode,
using the swinstall utility.
CAUTION You must consult the Release Notes with this product for important
details, particularly about required HP-UX patches. Install them before
proceeding.
1. Log in to the system as “root”.
2. Place the media in a local or remote CD-ROM drive.
3. Run swinstall, which behaves the same in the GUI interfaceasfor the
terminal interface. When the ““Specify Source”” box opens, select
““Source Depot Type”” to “Local CDROM”, or for a remote CD-ROM
driver, select for “Network Directory/CDROM” and set “Source Host
Name...”. Select “OK”.
4. Select the ACC Base Software and any other ACC items to be
installed,fromthelistofsoftwarebundles;openthe“Actions”menu
and select “Mark for Install”.
5. When all items have been marked, select “Install (analysis)”; select
“OK” and proceed.
NOTE A final Confirmation message informs you that a new kernel wil l be
rebuilt using the filesets installed, and the system will reboot. When you
are ready, select “Yes”.
The “Install (analysis)” window allows you to track s ummary progress of
theinstallationprocess.Usethe“Logfile”featuretodisplayadetailed
status, which is l ogged to /var/adm/sw/swagent.log.