ACC Installation and Configuration Guide

Chapter 2 41
Software Installation and Verification
Important Installation and Configuration Notes
Relocating EISA Mux Cards
NOTE When an EISA ACC multiplexer card has been installed and is
subsequently removed for re-installation into a different slot, t he
eisa_config program will prompt with the following message after the
system reboots:
eisa_config running in automatic mode to fix a configuration mismatch
Date: 02/12/96 09:50:40
One or more of the EISA boards that are listed in the configuration
are no longer responding. There are two possible causes:
(1) The board has been removed.
(2) The board is no longer responding because of a hardware
problem.
The board(s) listed below are not responding:
Slot <n>
eisa_config finished
Use the eisa_config program to correct this problem:
$ eisa_config
EISA: remove <n>
EISA: s
EISA: q
Youmusttype“s”next,tosavethechangetotheconfiguration.
NOTE Before attempting to start up the ACC subsystem, you must first modify
the TTGEN .answ file and run TTGEN to create a .tmem file.