ACC Installation and Configuration Guide

62 Chapter3
Protocol Configuration
Creating a Downloadable Firmware File
Step 2. Run the zlink utility on this new file.
% cd /opt/acc
% zlink z7200a/loopx25.zlnk
ZCOM Relocating Linker Rev:2.02 <900725.1546>
Absolute file ready: z7200a/loopx25.zabs
ZLINK: End. Rev.<900725.1546>
%
This creates the following files:
/opt/acc/z7200a/loopx25.zmap
/opt/acc/z7200a/loopx25.zabs
The .zabs file is the downloadable file. It should be referred to in the
MUX configuration linesin the “Interface-Definition” section of the ttgen
configuration file for the mux cards that will use these protocols. For
example:
Mux 3 0:8 /opt/acc/z7200a/loopx25.zabs