ACC Utilities Reference Guide

Chapter 5 143
ZTERM - Interactive Routine Interface
ZTERM Available Commands
RC - Set Terminal Receiver
Format: RC,ZLU1,[ZLU2],[rzlu],[rnode],[mode]
Sets up either the ZTERM primary ZLU as receiver for the specified
terminal ZLU1 or range of terminal ZLUs (ZLU1 to ZLU2 inclusive), or
can be used to set up an alternate program ZL U (rzlu & rnode)tobe
receiver for the terminal ZLU. If rnode is not supplied, it defaults to the
local node. Uses the zrcvr routine call.
RE - Read ZTERM ZLU
Format: RE,[wait]
Format: REHD,[wait]
Reads t he ZTERM program primary ZLU. If wait is specified, then the
program will continue to read the ZLU display the messages as they are
received. If no messages are received then an INT signal can be used to
interrupt the wait (this can usually be generated by using a ^C).
ZTERM> re
08:12:54 Message from program ZLU #0802 length 22 tag1=0000 tag2=0000
Lcn .00. .01. .02. .03. .04. .05. .06. .07. .08. .09. ASCII....ASCII....
000 5468 6973 2069 7320 6120 7465 7374 206D 6573 7361 This is a test message
010 6765 e.
TheREcommandcanalsobeusedtodisplaytheheaderofthemessage
by using the command modifier HD.
ZTERM> rehd
10:10:18 Message from program ZLU #0802 length 20 tag1=0001 tag2=0000
Lcn .00. .01. .02. .03. .04. .05. .06. .07. .08. .09. ASCII.....ASCII....
000 0200 007B 0322 2421 007B 0322 2421 0001 0000 0000 { ”$! { ”$!
010 0000 0000 0000 0000 0014
Lcn .00. .01. .02. .03. .04. .05. .06. .07. .08. .09. ASCII.....ASCII....
000 5A54 4552 4D73 3720 206D 6573 7361 6765 206E 6F2E ZTERMs7 message no.