ACC Utilities Reference Guide

146 Chapter5
ZTERM - Interactive Routine Interface
ZTERM Available Commands
The options have the following meanings:
LIst Displaythecontentsofthemessagesaswellasthe
statistical information.
AC Activate the terminal ZLU after every received
message (restart polling).
maxtime This parametersets a maximum runtime, in seconds. If
this is zero then the command runs without a time
limit, otherwise it will terminate after [maxtime]
seconds.
RZ - Read ZLU
Format: RZ,ZLU,[wait]
Format: RZHD,ZLU,[wait]
Reads any program ZLU. This command functions in exactly the same
way as the RE command, however as a ZLU number is entered, any
program ZLU can be read. Uses the zread routine call.
S7 - SS7 processing
Format: S7, [OF]
This command enables special processing for SS7 Level-1 devices . S7,OF
disables the SS7 processing.
When SS7 processing is enabled the RV, TX, RX, XM, and RL commands
are modified for testing with an SS7 level-1 protocol.
In particular, the first 2 bytes of all transmitted frames are sequenced to
ensure that any two consecutive frames will always contain different
data in these b ytes. The sequence number used for TX, XM and RL is
reset t o zero by the S7 command.
Any received frames 3 bytes long or shorter are discarded (assumed to be
FISUsorillegalforSS7).
While SS7 processing is enabled, the prompt is changed to “Z.SS7>” a s a
reminder.