ACC Utilities Reference Guide

22 Chapter1

ZDGEN - ZCOM Device Table Generator

Device Definition File Example

NOTE The information in this example may be out of date and should NOT be

used when configuring a ZCOM subsystem. Refer to the current Device

Definition file supplied (/opt/acc/cfg/zcomdevice.txt).

;==========================================================================+

; ;

; ZCOM device type description Rev.01.C <960325.1621> ;

; ;

;==========================================================================+

; ;

; There are 10 parameters for each device description. Each line can ;

; only define one device. Lines begin with ‘;’ or ‘*’ are treated as ;

; comments. Blank lines are also ignored. ;

; ;

; Device parameters: ;

; ;

; Type: Device type (sequential from 1,2,3,...) ;

; Name: 16 char max, capital, no leading or embedded spaces or comma ;

; Prot: Physical protocol type (0..63) ;

; Sc: Logical screen type (1..31, see MFORM) ;

; A: Number of bytes of Poll/Select addresses (0,1,2) ;

; Min: Lower bound of P/S address (0..255) ;

; Max: Upper bound of P/S address (0..255) ;

; Opt: Protocol options (bits 0 to 15 only) ;

; LOGFG: LTFLAG word for logical terminal table ;

; Module: Protocol module name ;

; ;

;==========================================================================+

; ;

; Device types 1 to 32 are for private use. Any specific or test device ;

; types may be defined in this range. ;

; ;

;==========================================================================+

* Type Name............Prot Sc A Min Max Opt LOGFG Module Refer-To