ACC Utilities Reference Guide

Chapter 3 75
ZLINK - Z80/Z180 Relocating Linker
Available Commands
Available Commands
The commands available in ZLINK are listed below. Following the
summary, each command is described in detail, in alphabetic order.
Square brackets are used to denote optional entries, and angle brackets
are used where actual text must be inserted into the command, as
indicated by the contents of the angle brackets.
? - help
* - comment
AB - specify absolute file name
AL - alignment mask
EN - end link
FO - force link if errors
HE - help
HX - HEX dump of absolute file
LN - transfer to ZLINK command file
LO - set logical address mode and origin
MA - produce link map
NA - specify module name
OLDF - use old format for ZABS output file
OR - set origin
PO - set physical address mode and origins
Q - quit and abort link
RE - relocate module
SN - snap file relocation
XR - produce cross reference
?-Help
The question mark command (?), (as well as the HE command), provides
information on the available commands. Use this command any time
during an interactive ZLINK session when assistance is required. If
either of the two help commands are followed by a specific command
name, then help for that particular command is supplied.
Format: ? [<command>]
<command> is any of the commands available in ZLINK. Only the first
two letters of each command are required. For example, ? NA. If the ? is
entered without t he command option, then the following information is
displayed.