ACC Utilities Reference Guide

80 Chapter3

ZLINK - Z80/Z180 Relocating Linker

Available Commands

PMENTTAB 0AB00 AB00 128. @(#)ZCOM Protocol Module Entry Point Table

@(#) ACC Rel B.02.40.00 for B.10.20 1997 pmenttab.

END$ 0AB80 AB80

Absolute file ready: z7400a/hdlc.zabs

NA - Name

Format: NA <name> [comment]

<name> specifies the name to be used for the module name. This na me is

written in a special record type to the absolute file, to identify the

module. The optional comment is also written in this record. If not

specified, ZLINK uses t he first eight characters of the absolute file name

specified in the AB or EN commands.

OLDF - Use Old Format

Format: OLDF

OLDF causes ZLINK to produce an absolute output file of type 9 in a

format compatible with so me older versions of the software. Do not use

this option unless specifically requested by the destination system.

OR - Set Origin

Format: OR < address> | <symbol> [, <limit> | <symbol> ]

Set address origin with optional limit. The logical address is set to the

value or symbol specified. This does not change the logical or physical

address modes, (see the LO and PO commands). If a the optional limit

parameter is specified, then ZLINK will check that code is not relocated

at any address higher than this limit. If the limit is not specified, then no

checking is performed o n the amount of code relocated.

If a symbol is specified for either parameter then it must be a predefined,

absolute symbol.