ACC X.25 Protocol User's Guide

Chapter 2 23
Installation
Installation Verification
The zmntr utility can be used to show that the Level 3 connections have
been established:
% ZMNTR
ZMNTR> tt,1,200
ZLU# Mx Pt Terminal Description....Rx.Mes Tx.Mes Error E.Rate State.......
0010 00 0L X25 DTE POS 226633004 2 10 0 0.00% Up,Link Estbd
0100 00 0V SVCI =0004 226633011 0 0 0 0.00% Up,Call Estbd
0020 00 1L X25DCE POS 226633004 2 10 0 0.00% Up,Link Estbd
0200 00 1V SVCO =0004 226633011 0 0 0 0.00% Up,Call Estbd
**** ** ** Message totals 4 20 0 0.00% ************
ZMNTR> ex
Step 7. Data can now be sent over the esta blis hed virtual circuit. In t his
example, messages are sent on ZLU 100. Two messages, 50 bytes in
length, are being sent with mode 0. Mode 0 is used to indicate no
response is desired.
% ZTERM
ZTERM> rc,100,200
ZTERM> tx,100,50,0,2,2
10:06:12 TX test complete!!!
ZTERM>