ACC X.25 Protocol User's Guide

Chapter 2 25
Installation
Using the X.25 Protocol Module
Using the X.25 Pr otocol Module
The Multi-protocol ACC Installation and Configuration Guide contains
thegeneralprocedureforcreatingdownloadablefirmwarefiles,creating
the ttgen configuration file, starting up the ACC subsystem with the new
protocoland new configuration. The X.25 specificrequirements are noted
below:
•Includethezx25.zrel protocol module when creating the .zabs
firmware file (non-PCI bus only).
• Refer to the section “Configuration” on page 29 in Chapter 3 ,
“ZX25D X.25 Protocol Driver,” for X.25 specific configuration
requirements when building the ttgen configuration file.
•Theprogramzx25d_init must be scheduled in order to use the X.25
protocol. The installation procedure will configure the zmasterd_list
file to automatically schedule this program when zmasterd is used to
start up the ZCOM subsystem.