HyperFabric Administrator's Guide (HP-UX 11i v1)

Configuring HyperFabric
Performing the Configuration
Chapter 4 97
Using SAM—HP-UX 11.0 and HP-UX 11i v1
This section describes how to use SAM to configure HyperFabric. For
information on how to use SAM to configure and deconfigure local
failover feature on HMP, see “Configuring HMP for Transparent Local
Failover Support - Using SAM” on page 118 and “Deconfiguring HMP for
Local Failover support - Using SAM” on page 119.
IMPORTANT If the global configuration file already exists, and you are running SAM
again (to change the file), you can keep or modify the existing
configuration information, in addition to adding new information
pertaining to new hardware.
Also, once you’ve completed your changes and SAM ends its processing,
you must stop HyperFabric (by running the clic_shutdown command or
using SAM) and then start HyperFabric (by running the clic_start
command or using SAM). Otherwise, your configuration information
changes will not take effect. See “Stopping HyperFabric” on page 144 and
“Starting HyperFabric” on page 125 for more information.
To use SAM to create the global configuration file on an HP 9000 system
running HP-UX 11.0 or 11i v1, follow these steps:
Step 1. Start SAM.
Step 2. Select the “Networking and Communications” area.
Step 3. Select “HyperFabric.”
All HyperFabric adapters installed in the system are listed; installed
adapters that are not yet configured show Not Configured in the
“Status” field.
Step 4. Highlight the adapter you want to configure.
Step 5. Pull down the “Actions” menu and select Configure Adapter.
Step 6. In the “Configure HyperFabric Adapter” screen, specify information for
the following fields:
• Internet Address—Required. The IP address of the adapter.