HyperFabric Administrator's Guide (HP-UX 11i v1)

Managing HyperFabric
Starting HyperFabric
Chapter 5126
/opt/clic/bin/clic_start
Using the clic_start Command
Run the clic_start command on each node to start the HyperFabric
management process on that node.
If you include /opt/clic/bin in your PATH statement, you can run the
command as it is shown below. Otherwise, you must include
/opt/clic/bin as part of the command name (that is,
/opt/clic/bin/clic_start).
You must be logged in as root to run this command.
The syntax is as follows:
clic_start
The clic_start -? command can be issued to display the online help
for clic_start, or look at the clic_start (1m) man page by issuing
the man clic_start command.
If HyperFabric is already running, you will receive an informational
(FYI) message telling you so. Your reaction to this message depends on
the situation:
• If you have simply forgotten (or did not know) that HyperFabric was
already running, you do not have to do anything.
• If you have changed the HyperFabric configuration with the
clic_init command or SAM, you must stop HyperFabric (by
running the clic_shutdown command or using SAM) and then start
HyperFabric (by running the clic_start command or using SAM).
See either “Using the clic_shutdown Command” on page 144 or
“Using SAM—HP-UX 11.0 and 11i v1 0nly” on page 145, whichever
is appropriate.
Using SAM—HP-UX 11.0 and 11i v1 0nly
To use SAM to start HyperFabric on an HP 9000 system running HP-UX
11.0 or 11i v1, complete the following steps:
Step 1. Start SAM.
Step 2. Select the “Networking and Communications” area.