HyperFabric Administrator's Guide (HP-UX 11i v1)

Troubleshooting HyperFabric
Replacing a HyperFabric Adapter
Chapter 6176
Replacing a HyperFabric Adapter
If OLAR is supported for the HP 9000 system and the HyperFabric
adapter, and you want to do OLR, see “Online Replacement (OLR)” on
page 56. The HP HyperFabric Release Notes contains information about
which HP 9000 systems and HyperFabric adapters OLAR is supported
for.
If you cannot or do not want to do OLR to replace a HyperFabric adapter,
follow these steps:
Step 1. Stop HyperFabric on the node where the faulty adapter is installed (see
“Stopping HyperFabric” on page 144).
Step 2. Depending on the type of HP 9000 the adapter is in, follow the steps in
the HP 9000’s documentation for installing the adapter.
Remember that, when you replace a HyperFabric adapter, you do not
have to re-install the HyperFabric software.
Step 3. Start HyperFabric on the HP 9000 (see “Starting HyperFabric” on
page 125).