HyperFabric Configuration Guidelines

Hyper Messaging Protocol (HMP)

are used only to show the flow of the information provided as input to the

clic_init command and SAM. Do not try to use these addresses in your

configuration.

Figure 13 Configuring the Transparent Local Failover feature

Using the configuration information in Figure 13, the information you

would specify when you run clic_init on each of the nodes is listed

below. This example is not an exact depiction of the prompts produced by

clic_init, but merely an example of the flow of information input. In

addition, you should not try to use the dummy addresses in your actual

configuration.

On node A: