Installing Enhanced AutoFS B.11.11.0503.1 from the Software Pack Media Second Edition HP-UX 11iv1 Manufacturing Part Number: B1031-90056 September 2005 United States © Copyright 2004-2005 Hewlett-Packard Development Company LP. All rights reserved.
Legal Notices The information in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be held liable for errors contained herein or direct, indirect, special, incidental or consequential damages in connection with the furnishing, performance, or use of this material.
OSF/Motif is a trademark of the Open Software Foundation, Inc. in the U.S. and other countries. NFS® is a registered trademark of Sun Microsystems, Inc. NIS™ and NIS+™ are trademarks of Sun Microsystems, Inc.
1 Installing from the Software Pack CD-ROM The bundle contains all the required patches plus the enablement product for this feature. To install Enhanced AutoFS B.11.11.0503.1 on your system, perform the following steps: NOTE Back up your system before installing this product. Step 1. Log in as root. Step 2. Mount the CD drive on to the desired directory.
Installing from the Software Pack CD-ROM Removing Enhanced AutoFS NOTE This command removes the product and reboots the system, leaving the bundle wrapper and the kernel patches on the system. The kernel patches included with the product bundle are recommended for the system. Therefore, HP advises not to remove them. For more information on managing patches on your system, see the "HP Patch Management" document.