A7011A & A7012A PCI-X 2-Port Gigabit Ethernet Card Installation Guide

Regulatory Information

EMI Statement (European Community)

Appendix A

EMI Statement (European Community)

NOTE This is a Class A product. In a domestic environment, this product may cause radio

interference, in which case you may be required to take adequate measures.

Laser Safety Statements

Laser Safety Statements - U.S. FDA/CDRH - Optical (laser) Transceiver

CAUTION The optical transceiver provided on the network interface card contains a laser system and is

classified as a “Class-I Laser Product” under a U.S. Department of Health and Human Services

(DHHS) Radiation Performance standard according to the Radiation Control for Health and

Safety Act of 1968. The Class I label and compliance statement are located on the optical

transceiver.

To ensure proper use of this product, please read this instruction manual carefully and retain for future

reference. Should the unit ever require maintenance, contact an authorized service location.

CAUTION Use of controls, adjustments or the performance procedures other than those specified herein

may result in hazardous radiation exposure. To prevent direct exposure to laser beam, do not

try to open the enclosure.

Laser Safety - European Union - Optical Transceiver Only

CAUTION The optical transceiver provided on the network interface card contains a laser system and is

classified as a “Class 1 Laser Product” per EN 60825-1, Safety of Laser products. Class 1 laser

products are considered safe and do not pose a biological hazard if used within the data sheet

limits and instructions.

To ensure proper use of this product, please read this instruction manual carefully and retain for future

reference. Should the unit ever require maintenance, contact an authorized service location.

CAUTION Use of controls, adjustments or the performance procedures other than those specified herein

may result in hazardous radiation exposure. To prevent direct exposure to laser beam, do not

try to open the enclosure.

There are no user serviceable parts nor any maintenance required for the optical transceiver. All adjustments

are made at the factory before shipment to customers. Tampering with or any attempt to modify the optical

transceiver will result in voided product warranty. It may also result in improper operation of the network

card circuitry and possible overstress of the laser source. Device degradation or product failure may result.