AB291A Fabric Clustering System Support Guide (12-port Switch), April 2004

HP 12-Port 4X Fabric Copper Switch Commands
Show Commands
Appendix B
202
show interface mgmt-ethernet
Synopsis:
The show interface mgmt-ethernet command shows the configuration of the Ethernet Management port on
the system controller.
Syntax:
show interface mgmt-ethernet
This command takes no card or port designation.
Command Modes:
User-execute and privileged-execute modes.
Privilege Level:
General read-only user.
Usage Guidelines:
The Ethernet Management port is an Out-of-Band Management (OBM) port that provides network access to
the system chassis in order to run remote CLI and Element Manager sessions. The port must be configured
before it can be used (Element Manager GUI is not supported in initial release of HP Fabric Clustering
System).
This command displays the administrative status of the interface port, its assigned IP address and subnet
mask, plus the IP address of the gateway port used to connect to the Ethernet Management port. If the
Ethernet host is directly connected to the Ethernet Management port, without having to go through Ethernet
switches, the default gateway-addr value is 0.0.0.0 (some gateway functions are not supported by HP Fabric
Clustering System).
Examples:
HP-IB# show interface mgmt-ethernet
===============================================================
Mgmt-Ethernet Information
===============================================================
mac-address : 00:05:ad:00:11:75
auto-negotiate : enabled
admin-status : up
ip-addr : 10.3.102.24
mask : 255.255.0.0
gateway-addr : 10.3.0.1
HP-IB#
Defaults:
This command has no defaults.