AB291A Fabric Clustering System Support Guide (12-port Switch), April 2004

HP 12-Port 4X Fabric Copper Switch Commands
Show Commands
Appendix B
205
show interface mgmt-serial
Synopsis:
The show interface mgmt-serial command displays the configuration of the Serial-Console port on the system
controller card.
Syntax:
show interface mgmt-serial
This command takes no card or port designation.
Command Modes:
User-execute and privileged-execute modes.
Privilege Level:
General read-only user.
Usage Guidelines:
The Serial-Console port is the initial connection point with the system chassis and is used to configure the
Ethernet Management and Management-InfiniBand ports. This port must be configured and a management
station attached before any interaction with the system chassis is possible.
The CLI always defaults to port 1 on the active controller card.
Examples:
HP-IB# show interface mgmt-serial
===============================================================
Mgmt-Serial Information
===============================================================
baud-rate : 9600
data-bits : 8
stop-bits : 1
parity : off
HP-IB#
Defaults:
This command has no defaults.
Related Commands:
“show interface mgmt-ethernet” on page 202
“show interface mgmt-ib” on page 204