AB291A Fabric Clustering System Support Guide (12-port Switch), April 2004

HP 12-Port 4X Fabric Copper Switch Commands
Show Commands
Appendix B
220
show trace
Synopsis:
Theshow trace command tracks the system program modules called by a system application for a specific
interface card.
Syntax:
show trace {app
appInt
[module
modInt
] [card
cardInt
]}
The syntax is described in the table below:
Command Modes:
User-execute and privileged-execute modes.
Privilege Level:
General read-only user.
Usage Guidelines:
This command is intended primarily for program debug under the direction of Support personnel.
The number of applications and modules may change between releases. The numbers assigned to applications
and modules may also change. Check application and module number assignments using CLI help (i.e.,?) for
entering command arguments.
Table B-36 show trace Command Syntax Descriptions
Syntax Description
app appInt Specify a system program application.
appInt is an integer between 1 and n, where n is an undetermined
number that changes between releases. appInt is the number of the
internal application to trace.
module
modInt
Indicates a module of the specified application. modInt is an integer
between 0 and n, where n is an undetermined number that changes
between releases. modInt the number of the program module in the
application to trace.
card
cardInt
Corresponds to a slot in the chassis. cardInt is an integer between 1 and
2 (for the HP Fabric Clustering System Switch).