AB291A Fabric Clustering System Support Guide (12-port Switch), April 2004

HP 12-Port 4X Fabric Copper Switch Commands
Administrative Commands
Appendix B
248
Defaults:
This command has no defaults.
Related Commands:
“copy” on page 252
“install” on page 266
“show card” on page 136
boot-config
Synopsis:
The boot-config configuration command is used to specify the system-image that should be used to initialize
the system firmware when the system powers-up, or is rebooted.
Syntax:
boot-config primary-image-source dir
Command Modes:
Global-configuration mode.
Privilege Level:
Unrestricted read-write user.
Usage Guidelines:
Enter the primary-image-source keyword, followed by the system-image directory. Specify an image directory
as an image source.
Do not specify image files that end in .img since these are compressed archives that must be installed first.
Examples:
HP-IB(config)# boot-config primary-image-source Release-1.1.0/build460
The example directs the system controller to use the Release-1.1.0/build460 directory when the
system-image to initialize itself. If this directory is not available, the system will not boot successfully.
Table B-56 boot-config Keywords
key word Decription
primary-image-s
ource
Specifies that the name of the new boot-config file is to follow.
Table B-57 boot-config Arguments
Argument Description
dir Enter the actual file name.