AB291A Fabric Clustering System Support Guide (12-port Switch), April 2004

HP 12-Port 4X Fabric Copper Switch Commands
Administrative Commands
Appendix B
286
Privilege Level:
Unrestricted or card-specific read-write user.
Usage Guidelines:
The card type must be specified before it may be enabled.
Examples:
HP-IB Example:
HP-IB(config-card-2)# type en4port1G
Defaults:
Fabric switch cluster connection type does not have to be specified because it is automatically detected and
configured when the system boots up.
Related Commands:
“shutdown” on page 279
“show card” on page 136
username
Synopsis:
The username command is used to create and manage administrative access to both CLI, GUI, and SNMP
(Element Manager GUI is not supported in initial release of HP Fabric Clustering System).
Syntax:
username user password passwd <-- must be executed 1st
username user no
username user disable
username user enable
username user community-string string
username user no-community-string
username user privilege priv1 [priv2] [priv3]
user and passwd are alphanumeric strings up to 34 characters each.
The privilege argument removes all existing privileges, and replaces them with them with the new ones.
Command Modes:
Global-configuration mode.
Privilege Level:
Unrestricted read-write user or general read-write user (change own password only).