AB291A Fabric Clustering System Support Guide (12-port Switch), April 2004

HP 12-Port 4X Fabric Copper Switch Commands
Administrative Commands
Appendix B
288
Examples:
The following example creates a user with HP Fabric Clustering System administrative privileges, as well as
an SNMP community-string.
HP-IB(config)# username ib-admin password ibadmin
HP-IB(config)# username ib-admin community-string ib-commstr
HP-IB(config)# username ib-admin privilege ib-rw
HP-IB(config)# username ib-admin enable
HP-IB(config)# exit
HP-IB# show user ib-admin
================================================================================
User Information
================================================================================
username : ib-admin
password : $1$xMC/.l6E$D8ZPG4CqYZNJ7R2AQoTBA1
snmp-community : ib-commstr
permission-level : ib-rw
admin-status : enabled
num-logins : 0
num-unsuccessful-logins : 0
last-login :
last-unsuccessful-login :
The following example disables a user but leaves the user account intact.
HP-IB(config)# username ib-admin disable
The following example removes a user account.
admin By default, the password is “admin”. The
default community string is “private”.
The admin user has general read-write privileges. This user
may view and modify the current configuration. However, the
admin user can change only its own user information, such as
the admin password.
guest The default password is “guest”. The
default community string is “public”.
The guest user has read-only privileges. This user may only
view the current configuration. The guest user cannot make
any changes during the CLI session.
Table B-77 Default User Accounts (Continued)
User Name Password Privilege