AB291A Fabric Clustering System Support Guide (12-port Switch), April 2004

Chapter 5
Administration and Management
HP-UX Host Administration and Management
49
Displaying the List of End-Nodes
Description: This parameter displays the list of end-nodes that are reachable for all specified adapters (i.e.
the Topology of the cluster). If an adapter is not specified using the -i parameter, the -T command displays
the topology information for every HP Fabric Clustering System interface configured on the host.
Syntax: itutil -T [-i interface name|-t transport type]
Example: itutil -T
Output Example:
========================================================================
Number of Interface Adapters on this node: 1
========================================================================
Interface Adapter Name : ib0
H/W Path : 0/4/1/0/0/0
Transport Type : IT_IB_TRANSPORT
IT API Version Number : 1.0
IA Software Version Number : 1.0
IA Firmware Version Number : 3.1.0
Firmware Type : Performance
IA supported transport service types : IT_RC_SERVICE
Number of Spigots(Ports) on IA : 2
Spigot specific Information
Spigot identifer : 1
Spigot online : YES
Num Network Addresses : 1
Primary Network Address : fe80::ca07:2001
Spigot identifer : 2
Spigot online : NO
Num Network Addresses : <Unassigned>
========================================================================
Topology information for online spigots :
========================================================================
Spigot identifer : 1
Spigot Primary LID : 0xa
Primary Network Address : fe80::ca07:2001
Configuration : Point-to-Point
Primary Remote LID : 0xb
Primary Remote Network Addr : fe80::2:c901:8a0:8a11
Node Description : iblp0091
Primary Remote LID : 0xa