AB291A Fabric Clustering System Support Guide (12-port Switch), April 2004

Chapter 5
Administration and Management
Switch Administration and Management
66
Exiting the CLI Session
To exit the CLI session, return to the user-execute or privileged-execute mode, and enter the logout command.
The CLI session is terminated and you are returned to the CLI login prompt.
For example:
HP-IB(config-if-fc-5/1)# exit all
HP-IB> logout
Login:
NOTE If you use Telnet or SSH to run a remote CLI session, the connection is dropped when you log
out, or vice-versa.
Specifying the Card/Port
In many cases, you are asked to identify the card and/or the ports on a card to which to apply configuration
commands. This section describes how to refer to slots and ports for configuration via the CLI.
Figure 5-1 Slot/Port Notation for the HP Fabric Clustering System Switch
Many CLI commands allow you to enter
• a card (or slot)#/port# pair
<Ctrl>u Delete text up to cursor.
<Ctrl>w Delete word up to cursor.
<Ctrl>z Return to user-privileged mode.
<Esc>b Move back one word.
<Esc>c Convert rest of word to uppercase.
<Esc>d Delete remainder of word.
<Esc>f Move forward one word.
<Esc>l Convert rest of word to lowercase.
down-arrow (i) Get next command from history.
up-arrow (h) Get previous command from history.
left-arrow (f) Move cursor left one character.
right-arrow (g) Move cursor right one character.
Table 5-4 Key Stroke Shortcuts (Continued)
key description
Slot 1