AB291A Fabric Clustering System Support Guide (12-port Switch), April 2004

Chapter 5
Administration and Management
Switch Administration and Management
93
Step 7. Enter multiple access privileges in the order shown in “Setting Administrative Roles” on page 95.
HP-IB(config)# username ib-admin privilege ib-rw
where, ib-admin is the name of the user account, privilege is a mandatory keyword, and ib-rw,
ip-ethernet-ro, and fc-rw are access privileges. Valid access privileges are described in “Setting
Administrative Roles” on page 95.
All new user accounts are now enabled and ready for use.
Step 8. Exit the global-configuration mode.
Step 9. View the new user account information.
HP-IB(config)# exit
HP-IB# show user ib-admin
============================================================================
User Information
============================================================================
username : ib-admin
password : ib-passwd
snmp-community : ib-commStr
permission-level : ib-rw
admin-status : enabled
num-logins : 0
num-unsuccessful-logins : 0
last-login :
last-unsuccessful-login :
HP-IB#
Deleting a User Account
Step 1. Log in as the unrestricted user.
Only a user with unrestricted permissions may create and modify user accounts.
HP-IB# Login: super
Password: xxxx
HP-IB>
Step 2. Enter the privileged-user mode.
HP-IB> enable
HP-IB#
Step 3. Enter the global-configuration mode.
HP-IB# configure
HP-IB(config)#
Step 4. Enter the username command with the name of the user, and the no keyword.
For example:
HP-IB(config)# username ib-admin no