AB378A Fibre Channel Mass Storage Adapter Installation Guide, December 2006

Chapter 2
17
2 Fibre Channel Adapter Installation for
OpenVMS
This chapter contains installation prerequisites, guidelines, and procedures for the AB378A host bus adapter.
This chapter addresses the following topics:
“Prerequisites” on page 17
“Installing Driver Software” on page 18
“Installing Adapter Hardware” on page 18
“Attaching the Adapter to Other Fibre Channel Devices” on page 20
“Verifying the Fibre Channel Adapter Installation” on page 20
“Additional Configuration Information” on page 22
“LED Interpretation” on page 22
Thank you for purchasing HP I/O Cards
If you are installing an HP I/O card as an add-in device, please review this document before attempting
installation.
If this card was factory installed in your server, see “Verifying the Fibre Channel Adapter Installation” on
page 20.
HP welcomes your input. Please email us at:
[e-mail]
with comments or suggestions on HP I/O Cards or related documentation.
All product documentation, including a comprehensive Support Guide, Installation Guide, Release Notes,
Support Matrix are available online at: http://docs.hp.com
1. Within the “Internet & Networking” category select “I/O Cards and Networking Software”
2. Select “Fibre Channel”
3. Click on the Fibre Channel documentation product.
Prerequisites
Before installing the adapter, follow these steps:
Step 1. Verify compliance with supported sonfigurations using the HP Fibre Channel Host Bus Adapter
Support Matrix at:
http://docs.hp.com/en/netcom.html#Fibre%20Channel
Step 2. Determine if the adapter is a Customer Replaceable Unit (CRU) using the HP Fibre Channel Host
Bus Adapter Support Matrix. If the adapter is not a CRU, contact your HP representative for
installation assistance.
Field Replaceable Units (FRUs) must be installed or replaced by qualified Hewlett-Packard service
representatives only. CRUs can be installed or replaced by customers or qualified Hewlett-Packard
service representatives.
Step 3. Make sure that you have everything that you need to install the adapter.
• Verify that you have the following items:
— Grounding wrist strap
— Fibre Channel driver software media (included with the OS or application CD)
— Fibre Channel host bus adapter with an optical port protector attached (not included with
all adapters)