AB378B Fibre Channel Mass Storage Adapter Installation Guide, December 2006

Fibre Channel Adapter Installation for HP-UX
LED Interpretation
Chapter 1
11
LED Interpretation
Obtaining Card Information after Installation
Example of Card information after Installation
# fcmsutil /dev/fcd2
Vendor ID is = 0x001077
Device ID is = 0x002422
PCI Sub-system Vendor ID is = 0x00103c
PCI Sub-system ID is = 0x0012d6
PCI Mode = PCI-X 133 MHz
ISP Code version = 4.0.85
ISP Chip version = 3
Topology = PTTOPT_FABRIC
Link Speed = 4Gb
Local N_Port_id is = 0x030100
Previous N_Port_id is = None
N_Port Node World Wide Name = 0x50060b00006074ad
N_Port Port World Wide Name = 0x50060b00006074ac
Switch Port World Wide Name = 0x200100051e352af4
Switch Node World Wide Name = 0x100000051e352af4
Driver state = ONLINE
Table 1-3 AB378B LED Interpretation Table
HBA State
Yellow
LED
(4 Gbps)
Green
LED
(2 Gbps)
Amber
LED
(1 Gbps)
Comments
Power OFF OFF OFF OFF Card doesn’t have power
Power ON ON ON ON Card powered on and not initialized
Power ON 1 Flash/s 1 Flash/s 1 Flash/s After firmware initialization AWAITING LINK-UP
All flashing at the same time
Firmware
Fault
2 Flash/s 2 Flash/s 2 Flash/s All three LEDs flash in continuous sequence
1 Gbps Link
UP/ACT
OFF OFF ON
5 Flash/s
ONLINE
IO Activity
2 Gbps Link
UP/ACT
OFF ON
5 Flash/s
OFF ONLINE
IO Activity
4 Gbps Link
UP/ACT
ON
5 Flash/s
OFF OFF ONLINE
IO Activity