AB378B Fibre Channel Mass Storage Adapter Installation Guide, February 2007

Chapter 1
5
1 Fibre Channel Adapter Installation for
HP-UX
This chapter contains installation prerequisites, guidelines, and procedures for the AB378B host bus adapter.
This chapter addresses the following topics:
“Prerequisites” on page 5
“Important Patches and Updates” on page 6
“Installing Driver Software” on page 7
“Installing Adapter Hardware” on page 8
“Attaching the Adapter to Other Fibre Channel Devices” on page 10
“Verifying the Fibre Channel Adapter Installation” on page 11
“LED Interpretation” on page 12
“Obtaining Card Information after Installation” on page 12
“Verifying Connectivity” on page 14
“Interpreting Legacy Hardware Paths (HP-UX 11i v1 and 11i v2)” on page 14
“Interpreting Lunpath Hardware Paths (HP-UX 11i v3)” on page 17
Thank you for purchasing HP I/O Cards
If you are installing an HP I/O card as an add-in device, please review this document before attempting
installation.
If this card was factory installed in your server, see “Verifying the Fibre Channel Adapter Installation” on
page 11.
HP welcomes your input. Please email us at:
[e-mail]
with comments or suggestions on HP I/O Cards or related documentation.
All product documentation, including a comprehensive Support Guide, Installation Guide, Release Notes,
Support Matrix are available online at: http://docs.hp.com
1. Within the “Internet & Networking” category select “I/O Cards and Networking Software”
2. Select “Fibre Channel”
3. Click on the Fibre Channel documentation product.
Prerequisites
Before installing the adapter, follow these steps:
Step 1. Verify compliance with supported configurations using the HP Fibre Channel Host Bus Adapter
Support Matrix at:
http://docs.hp.com/en/netcom.html#Fibre%20Channel
Step 2. Determine if the adapter is a Customer Replaceable Unit (CRU) using the HP Fibre Channel Host
Bus Adapter Support Matrix. If the adapter is not a CRU, contact your HP representative for
installation assistance.
Field Replaceable Units (FRUs) must be installed or replaced by qualified Hewlett-Packard service
representatives only. CRUs can be installed or replaced by customers or qualified Hewlett-Packard
service representatives.
Step 3. Check the following conditions:
• To verify that the /usr/bin, /usr/sbin, and /sbin directories are in the PATH, enter the
following command:
echo $PATH
• Verify that you have the following items: