AB379B Fibre Channel Mass Storage Adapter Installation Guide, February 2007
Table Of Contents
- AB379B Fibre Channel Mass Storage Adapter Installation Guide
- 1 Fibre Channel Adapter Installation for HP-UX
- Prerequisites
- Important Patches and Updates
- Installing Driver Software
- Installing Adapter Hardware
- Attaching the Adapter to Other Fibre Channel Devices
- Verifying the Fibre Channel Adapter Installation
- LED Interpretation
- Obtaining Card Information after Installation
- Verifying Connectivity
- Interpreting Legacy Hardware Paths (HP-UX 11i v1 and 11i v2)
- Interpreting Lunpath Hardware Paths (HP-UX 11i v3)
- Components of Lunpath Hardware Paths
- Fibre Channel
- 2 Fibre Channel Adapter Installation for OpenVMS
- Prerequisites
- Installing Driver Software
- Installing Adapter Hardware
- Attaching the Adapter to Other Fibre Channel Devices
- Verifying the Fibre Channel Adapter Installation
- Additional Configuration Information
- LED Interpretation
- A Technical Specifications and Regulatory Information
- AB379B Technical Specifications
- FCC Statement (For U.S.A.)
- Canada
- EMI (Australia and New Zealand)
- VCCI (Japan) (PCI Card Only)
- EMI Statement (European Community)
- Laser Safety Statements
- AB379B Declaration of Conformity
Technical Specifications and Regulatory InformationVCCI (Japan) (PCI Card Only)Appendix A29VCCI (Japan) (PCI Card Only)This equipment complies with the Class A category for information technology equipment based on the rulesof Voluntary Control Council for Interference by Information Technology Equipment. When used in aresidential area, radio interference may be caused. In this case, the user may be required to take appropriatecorrective actions.Figure A-1 VCCI Regulatory StatementEMI Statement (European Community)NOTE This is a Class A product. In a domestic environment, this product may cause radiointerference, in which case you may be required to take adequate measures.Laser Safety StatementsLaser Safety Statements - U.S. FDA/CDRH - Optical (laser) TransceiverCAUTION The optical transceiver provided on the network interface card contains a laser system and isclassified as a “Class-I Laser Product” under a U.S. Department of Health and Human Services(DHHS) Radiation Performance standard according to the Radiation Control for Health andSafety Act of 1968. The Class I label and compliance statement are located on the opticaltransceiver.To ensure proper use of this product, please read this instruction manual carefully and retain for futurereference. Should the unit ever require maintenance, contact an authorized service location.CAUTION Use of controls, adjustments or the performance procedures other than those specified hereinmay result in hazardous radiation exposure. To prevent direct exposure to laser beam, do nottry to open the enclosure.Laser Safety - European Union - Optical Transceiver Only
- A Technical Specifications and Regulatory Information
- Interpreting Lunpath Hardware Paths (HP-UX 11i v3)