ACC Error Guide

ZMON Error Messages

Chapter 6130

Message 103 - Card <number> inconsistent or corrupted IFT

Explanation: During the restart/shutdown of a Mux card ZMON

reports the last backplane activity that the DAM

attempted to the card. This information is contained in

the ZCOM IFT (interface table) and must be read via

the /dev/zmon device file. This error indicates the read

has failed for some reason. The restart/shutdown of the

card is abandoned if this error is encountered.

Action: Report the problem to the nearest HP representative.

Message 104 - Card <number> restart ignored because card is

unusable

Explanation: ZMON is unable to restart the Mux card because of a

hardware or configuration problem. If any selftest

failures or timeouts have been reported there may be a

hardware problem. If the card is reported as absent,

then the problem may be simply that the card is not

installed, or not installed in the correct slot. The ACC

driver space file information under

/usr/conf/space.h.d may be inconsistent with the

TTGEN configuration file (.answ). Check the ioscan-f

output against the Mux statements in the .answ file.

ZMNTR can display the Mux configuration with the

MX command.

Action: Replace hardware or correct configuration problem;

then restart ZCOM system.

Message 105 - Card <number> can’t open device: <reason> Device file

Explanation: ZMON is unable to open the device file for Mux

<number>. The reason given is the explanation of a file

system error that is preventing access to the file (e.g.

file does not exist, or permissions problem).

Action: Correct the problem and restart the ZCOM system.