ACC Error Guide

ZNODE Error Messages
ZNODE Error Messages
Chapter 7162
ZNODE Error Messages
Message 100 - Out of memory
Explanation: This message is issued when there is not enough
memory in the system to complete the task requested
of znode.
Action: Free up some memory resources and try again.
Message 102 - Couldn’t get <name>/<name> service from /etc/services
Explanation: This message is issued when znode fails to obtain the
znode name service from /etc/services.
Action: To add the name service manually, refer to preceding
topic “Adding Naming Services”.
Message 103 - Couldn’t create socket, error: <reason>
Explanation: This message is issued when znode fails to create a
socket.
Action: If the reason for the failure is related to shortage of
system resources or that networking subsystem has
not been started up, correct it and retry. For other
unresolvable reasons, contact your HP support
representative.
Message 104 - Couldn’t bind to socket, error: <reason>
Explanation: This message is issued when znode fails to bind a
socket to an address.
Action: If the reason for the failure is related to shortage of
system resources, inadequate access permission, or
X.25 line is not working; correct the problem and retry.
For other unresolvable reasons, contact your HP
support representative.