ACC Error Guide

TTGEN Error Messages
Errors
Chapter 8204
Error 283: “%s”(%d): Two Udata statements were detected for Term
entry %d. Only one Udata is allowed per Term entry
Explanation
Action: Remove one of the Udata statements.
Error 284: “%s”(%d): An Ldata statement can only be used after a Term
or Lterm entry, or after an Ldata statement following a Term or Lterm
entry.
Explanation
Action: Move the Ldata statement to the correct place in the
configuration file.
Error 285: “%s”(%d): A Udata statement can only be used after a Term
or Lterm entry
Explanation
Action: Move the Udata statement to the correct place in the
configuration file.
Error 286: “%s”(%d): The application number, %d, for the Logical-Data
area, %s, for an Ldata/Udata entry does not match the application
number, %d, for the Term/Lterm entry associated with the Ldata/Udata
entry
Explanation
Action: Correct the application number in the Term/Lterm
definition or in the Logical-Data definition.
Error 288: “%s”(%d): Bad datadelay %s (range %d . .%d)
Explanation
Action: Choose a valid value for datadelay in the range 0 to
100. The default value of 5 milliseconds has been
chosen after careful performance measurements by
Hewlett-Packard. The default value is strongly
recommended.