ACC Error Guide

TTGEN Error Messages
Warnings
Chapter 8 213
Warning 343: “%s %d”: Invalid %s value (range %d..%d or %d..%d in
bps), using default of %d.
Action: Change to an appropriate value if the default is not
acceptable.
Warning 344: “%s %d”: CLR bit set but CNT bit is not set in the VC
option word, setting CNT bit to 1.
Action: Set the CNT bit in the VC option word.
Warning 345: “%s”(%d): Application number should be 10 for a X.25
link terminal.
Action: Change to the appropriate value.
Warning 346: “%s %d”: There are more incoming SVC's defined than
specified in the LCN subscription in the X.25 link term entry.
Action: Check the LCN range.
Warning 347: “%s %d”: There are more two-way SVC's defined than
specified in the LCN subscription in the X.25 link term entry.
Action: Check the LCN range.
Warning 348: “%s %d”: There are more outgoing SVC's defined than
specified in the LCN subscription in the X.25 link term entry.
Action: Check the LCN range.
Warning 349: “%s %d”: PVC has not been assigned a LCN. LCN will be
dynamically assigned when the X.25 link is enabled.
Action: Configure a LCN for the PVC.
Warning 360: “%s”(%d): Re-defining interface %d port %d subch %d
(Severity 1)
Explanation Interface card has already been defined previously.
Action: Delete duplicate definition or change the interface card
number.