ACC Error Guide

PCAPTURE Log Messages

Chapter 10 225

Message 5 - Bad ZREAD call, error: <reason>

Explanation: This message is issued when an attempt to read from

the pcapture ZLU has failed. This will be accompanied

by a text reason message from the ZCOM subsystem.

Action: Address the reason and run pcapture again. Note that

pcapture will try zread again until the maximum

number of reads has been exceeded. Restart pcapture.

Message 6 - Max ZREAD error exceeded - terminating

Explanation: This message is issued when the number of zread

errors has exceeded the maximum number of zread

errors allowed. The zread error will have been logged

before this error is logged.

Action: Address the zread error.

Message 7 - End of pcapture

Explanation: This message is issued when the pcapture program is

about to exit.

Action: If the pcapture program terminates abnormally, try to

correct the problems that will be displayed prior to this

message. Do nothing if it is a normal termination.

Message 8 - Unexpected message type received <error>

Explanation: This message is issued when a message with an

unknown message type has been read from the

pcapture primary ZLU.

Action: None; however if this problem persists, contact your

HP support representative.