ACC Error Guide

ZX25D System Messages
CLASS: Normal 400-499
Chapter 12238
CLASS: Normal 400-499
zx25d 400 X.25 link ZLU (<#>) is larger than zx25_max_zlu (<#>)!
Increase the size of the kernel tunable zx25_max_zlu in /stand/system.
Explanation: The system tunable zx25_max_zlu specifies the
maximum value allowed for an X.25 ZLU. The default
value for this parameter is 16,384. While initializing
the specified link, it was determined that the X.25
link’s ZLU number was larger than this value. The
X.25 protocol driver is unable to initialize this X.25 link
due to this error. The X.25 link will not be usable.
Action: Increase the value of zx25_max_zlu in /stand/system
and rebuild your system using mk_kernel.
zx25d 401 zset_rcvr() for ZLU <#> unexpectedly failed with error <#>.
Explanation: The zset_rcvr routine is used to instruct the ZCOM
subsystem to deliver all X.25 protocol status and data
messages to the X.25 Protocol driver event handler
routine. This routine has unexpectedly failed. This is a
serious error which will prevent the X.25 driver from
initializing the indicated X.25 link ZLU. The X.25 link
ZLU has been marked as unusable. There are no
known causes for this failure.
Action: Check the error returned against those listed in this
guide and take corrective action as necessary. If the
problem persists and you are unable to determine its
cause or the error code indicates a probable internal
defect, contact your HP support representative.