ACC Error Guide

ZX25D System Messages
CLASS: Normal 400-499
Chapter 12 245
zx25d 412 The zsend() of unsolicited status failed with error <#>.
Src ZLU = <#>, Dest ZLU = <#>, Status = <#>.
Explanation: Unsolicited status message numbers 64 through 85 and
110 through 128 are generated by the X.25 protocol
driver. These status messages are sent to all
applications that have set themselves up as receivers
on the VC ZLUs or have called the zx25l2stat_rcvr()
routine. The X.25 Protocol driver uses the zsend
routine to pass these status messages to the
appropriate applications. This routine has
unexpectedly failed. This may have a severe
consequence for the application depending on the
particular status and use made of it by the application.
The Src ZLU parameter is the VC or X.25 Link ZLU
associated with the status message. The Dest ZLU is
the application’s program ZLU that the message was
being queued on. The Status parameter is the specific
unsolicited status code that was being send. See
Appendix A for more information on unsolicited status
messages and a list of the different status codes.
Action: Check the error returned against those listed in this
guide and take corrective action as necessary. If the
problem persists and you are unable to determine its
cause or the error code indicates a probable internal
defect, contact your HP support representative.
zx25d 413 Zc_zlumapt() of X.25 Link ZLU <#> failed with error <#>.
Explanation: The Zc_zlumapt is used to determine if the X.25 link
ZLU has been mapped to another ZCOM ZLU and to
make sure that the target mapped ZLU is a terminal
ZLU. This routine has unexpectedly failed. Most likely
this is due to an application programming error. That
is, the X.25 link ZLU was incorrectly mapped to
another ZCOM ZLU.
Action: Check the error returned against those listed in this
guide and correct the application program.