ACC Error Guide

ZX25D System Messages
CLASS: Normal 400-499
Chapter 12246
zx25d 414 Zc_zlumapt() of X.25 VC ZLU <#> failed with error <#>.
Explanation: The Zc_zlumapt is used to determine if the X.25
Virtual Circuit ZLU has been mapped to another
ZCOM ZLU and to make sure that the target mapped
ZLU is a terminal ZLU. This routine has unexpectedly
failed. Most likely this is due to an application
programming error. That is, the X.25 VC ZLU was
incorrectly mapped to another ZCOM ZLU.
Action: Check the error returned against those listed in this
guide and correct the application program.
zx25d 415 There are more PVCs subscribed to (<#>) than configured
(<#>) for the X.25 Link ZLU <#>.
Explanation: The X.25 link ZLU indicated did not have enough PVC
ZLUs defined to fulfil the X.25 subscription (last_pvc).
This may cause operational errors as some of the
subscribed PVC Logical Channels will not be usable. If
a packet arrives on an unusable PVC, the X.25 driver
will automatically generate a Reset Request.
Action: Correct the X.25 configuration. You may either change
the last_pvc parameter for the X.25 link ZLU or add
more PVC Term entries to the TTGEN configuration
file.
zx25d 416 There are more two-way SVCs subscribed to (<#>) than
configured (<#>) for the X.25 Link ZLU <#>.
Explanation: The X.25 link ZLU indicated did not have enough
two-way outgoing SVC ZLUs defined to fulfil the X.25
subscription (first_outsvc and last_outsvc). This may
cause operational errors as the network may attempt to
establish more calls than you have available Virtual
Circuits to accept them on. If this should occur, the
inbound call will automatically be cleared with an
appropriate error. In addition, your application will not
have as many outgoing SVCs as expected.