ACC Error Guide

ZX25D System Messages
CLASS: Protocol 600-699
Chapter 12274
CLASS: Protocol 600-699
zx25d 600 ZCOM has been shutdown. The ACC X.25 subsystem is
now down!
Explanation: The ZCOM subsystem was shutdown by a user issuing
a zmasterd stop command. The ACC X.25 subsystem
will automatically shut itself down when this occurs.
The ACC X.25 subsystem requires the ZCOM
subsystem in order to operate.
Action: No action is necessary. This is an informational
message.
zx25d 601 Link ZLU <#> not established on enable.
Mux= <#>, Port= <#>, Subchannel= <#>.
Explanation: This message is logged if an X.25 link has been enabled
but the X.25 subsystem was unable to establish X.25 at
level 2. Usually this is because the remote
system/device is not responding. The X.25 link will
automatically come up when the remote system
responds.
Action: No action is necessary. This is an informational
message.
zx25d 602 Link ZLU <#> disconnected due to DISABLE request.
Mux= <#>, Port= <#>, Subchannel= <#>.
Explanation: The X.25 link has been disconnected due to a user or
application issuing a request to disable the X.25 link
ZLU. After this message, the X.25 link will not respond
to level 2 protocol packets.
Action: No action is necessary. This is an informational
message.