ACC Error Guide

SNA/ACC Error Log Messages
SNACC Error Messages
Chapter 13294
snacc 00183: ERROR (0xB7): Unable to fetch the ZCOM logical terminal
table from the ACC subsystem. Function called: <func name>; Return
code: <#>
Explanation: Failed to establish a ZCOM link. zinfo() returned a
ZCOM error while retrieving information on a specific
logical terminal table entry.
Action: Refer to Chapter 2, “ZCOM Error Codes,” to determine
the error condition.
snacc 00184: ERROR (0xB8): Unable to setup callback function.
Function called: <func name>; Return code: <#>
Explanation: Failed to establish a ZCOM link. Unable to set up a
ZCOM callback function. This callback function is
called by the ZCOM subsystem to deliver data and
event information to the SNAplus2 subsystem. Restart
the ZCOM subsystem if needed. If the problem persists,
contact your local HP support personal.
Action: The ZCOM subsystem was not started properly. See
Chapter 2, “ZCOM Error Codes,” for more information
on the ZCOM error condition.
snacc 00185: ERROR (0xB9): Unable to setup as terminal receiver.
Function called: <func name>; Return code: <#>
Explanation: The ttgen configuration file does not contain the proper
terminal configuration information.
Action: Refer to the ACC SNAPlus2 Link Software User’s
Guide for detailed SNA/ACC terminal configuration
information. Also see Chapter 2, “ZCOM Error Codes,”
for more information on the specific error that
occurred.
snacc 00186: ERROR (0xBA): Unable to allocate a ZCOM buffer.
Function called: <name>; return pointer: <buffer address>
Explanation: The ZCOM subsystem has been shutdown, the ZCOM
buffer pool has been configured too small, or there is a
memory leak problem.