ACC Error Guide

ZCOM Error Codes
Meanings of the Error Codes
Chapter 232
ZEPTLINK (-35): Corrupted PTT group linkage
Explanation: This error is returned whenever the ZCOM subsystem
discovers an inconsistency in the group linkage of
physical terminals. This error could occur if the ZCOM
kernel memory tables are corrupt.
Action: Contact your HP support representative.
ZERCODE (-36): Illegal request code in header
Explanation: This error is returned when an internal defect in the
product is detected.
Action: Contact your HP support representative.
ZETXCSYNC (-37): Tx comp. with none outstanding
Explanation: This error is returned whenever the ZCOM drivers
detect a software synchronization problem between the
ZCOM drivers and the Mux interface card firmware.
Action: Contact your HP support representative.
ZETXCLEN (-38): Write comp. lengths mismatch
Explanation: This error is returned whenever the ZCOM drivers
detect a software synchronization problem between the
ZCOM drivers and the Mux interface card firmware.
Action: Contact your HP support representative.
ZENOTXBUF (-39): Interface out of Tx buffers
Explanation: This warning is only reported by the ZCOM driver
when the Mux interface runs out of buffers to process
new requests for a particular port. This may occur
when the Mux is in an abnormal busy condition.
Normally, this requires no operator intervention and
the Mux should recover. However, if it occurs
consistently, it may indicate a Mux firmware problem,
a Mux overload, or an invalid Port-Limit parameter.
Action: Decrease Port-Limit parameter value in the TTGEN
configuration file; check the Mux firmware for Mux
overloading using the zmntr “mx” command.