ACC Error Guide

ZCOM Error Codes
Meanings of the Error Codes
Chapter 2 53
ZeNOT_IN_LLIO (-128): DAM is not in the LLIO mode
Explanation: This error is returned when a LLIO “RESET” request
is issued while the card is in a normal runtime
operating mode. This command is not allowed without
first running zmasterd stop or zmon stop.
Action: Run zmasterd stop or zmon stop before attempting to
issue a reset command.
ZeSTOPPED_BY_DISABLE (-129): Request stopped by “DISABLE”
Explanation: When the DAM receives a LLIO “DISABLE” request, it
will terminate any request in progress with this error
code. Typically this is due to running “zmon stop” or
“zmasterd stop”.
Action: No action is necessary.
ZeBAD_RUNBP_RESP (-130): Bad response from Mux firmware
Explanation: After downloading the firmware onto the ACC Mux
card, the DAM instructs the card using a backplane
command to begin executing its firmware. This error is
returned when that command has returned an
unexpected result (e.g. non-zero). There are many
potential reasons for this problem. These include a
corrupt firmware download file, an internal defect in
the firmware itself, or some form of hardware failure.
Action: Run diagnostics on the card and verify that the
firmware file (located in /opt/acc/<card-type>/) is not
compromised in any way. If this message occurs
frequently or unusual behavior is exhibited by the
ZCOM subsystem, contact your HP support personnel.