ACC Error Guide

ZCOM Status Codes
Terminal State Control Status Codes
Chapter 368
Terminal State Control Status Codes
Status Code Status Message/Description
TM_OK(00) No error detected
The request was performed with no detected problem.
TM_MUST_DSBL(01) Terminal must be disabled
For a terminal control request the terminal must be
disabled.
TM_ROLL_FULL(02) Too many terminals on port
No more terminals can be added to the requested port
unless an existing one is moved to another port or
deleted.
TM_INV_TERM(03) Invalid terminal number
A request has been made to a terminal which has not
been initialized, or the terminal number is outside of
the valid range of terminals for the interface.
TM_INV_REQ(04) Invalid request code
The request code was not recognized by the multiplexer
firmware.
TM_NO_PORT(05) Terminal not assigned to port
The terminal must be initialized before further control
requests can be made.
TM_ILL_TYPE(06) Protocol not loaded
The requested protocol is not currently available on the
multiplexer. The terminal type is wrong or a new
download file with the required protocol should be
obtained.
TM_INV_PORT(07) Invalid port number
Port numbers must be in the range zero (0) to seven (7).