ACC Error Guide

ZCOM Status Codes
Port Configuration Status Codes
Chapter 3 71
Port Configuration Status Codes
Status Code Status Message/Description
PT_OK(00) No error detected
The request was performed with no detected problem.
PT_INV_PORT(01) Port number out of range
Port numbers must be in the range zero (0) to seven (7).
PT_BAD_PARM(02) Bad parameter specified
The port request code was not recognized.
PT_NOT_DSBL(03) Whole port must be disabled
All terminals configured on this port must be disabled
before the port can be re-configured.
PT_BAD_BAUD(04) Bad baud rate
The requested baud rate cannot be configured.
PT_ILL_SCLK(05) Illegal clock source
The requested clock source cannot be configured.
PT_ILL_PMODE(06) Illegal port mode
The port mode parameter is incorrect.
PT_BAD_PORT(07) Port failed selftest
The port failed it’s selftest when the multiplexer was
last reset and cannot be used.
PT_NO_BREAK(08) No break routine
The request attempted to set the break routine when
none was available.
PT_BAD_XCLK(09) Clock multiplier not compatible with mode
The clock multiplier must be set to X1 when
synchronous mode is selected.