ACC HDLC/LAP-B (ABM) User's Guide

Software Installation and Verification
Installation Verification
Chapter 224
Installation Verification
A sample configuration file /opt/acc/cfg/lapb_sample.answ file is
provided with the ACC Developer Software Suite product. This sample
file can be used to verify that the HDLC/LAP-B (ABM) protocol module
has been properly installed and is functional. Note that you may need to
customize this file, to reflect the location of the mux card(s) and to reflect
the mux ports to be used. The lapb_sample.answ file is shown in
Appendix A, “Sample Configuration Files,” on page 55.
The steps in the verification process are listed below. It is assumed that
the ACC Developer Software Suite product is installed on the system,
and that there is at least one ACC Mux card installed with a cable and
mux panel attached.
At least one loopback cable should be used to connect two of the ports on
the mux panel. For the configuration file provided, it is assumed that the
first two ports of the mux card are connected with a loopback cable, and
that the end of the cable marked “Int” is connected to port 0.
Using the HDLC/LAP-B (ABM) Protocol Module
The ACC Installation and Configuration Guide contains the general
procedure for configuring the network configuration file, creating
customized downloadable firmware files (except for T1/E1 4-channel
cards), and starting up the ACC subsystem with the new protocol and
new configuration.
Refer to Chapter 4, Protocol Specific Configuration, in this manual for
HDLC/LAP-B (ABM) specific configuration requirements when building
the network configuration file.