ACC Utilities Reference Guide

TTGEN - ZCOM System Table Generator
Creating the TTGEN Configuration File
Chapter 234
TTGen Control Line
This line must precede all the other configuration and definition
sections. It is to indicate that the source file is for TTGEN. TTGEN will
complain if this line is missing. There is no configuration information
that goes with this section. Comments or “#include” statements may
appear before this line. For example:
#include “TTGENdefine”
TTGEN
Configuration
NOTE #include “TTGENdefine” defines the configuration words used for HDLC
and X.25.
Configuration Parameters
The Configuration section is used to define the global parameters for the
ZCOM message system. Some of these parameters have default values
that will be used if the parameter is not specified. However, it is
recommended that all values are entered, since the default values will
not be optimal for every configuration.
Note that throughout this chapter, the term “Terminal ZLU” is used to
refer to a physical or logical entity, not necessarily an actual physical
terminal device. For example, a terminal ZLU might refer to a physical
entity such as a HDLC/LAP-B link or a terminal. A terminal ZLU could
also refer to a logical entity such as a Virtual Circuit or “loopback
protocol” module.