ACC Utilities Reference Guide

TTGEN - ZCOM System Table Generator
Creating the TTGEN Configuration File
Chapter 256
Terminal-Definition
This section specifies all the terminals on the system. Note that the term
“terminal” is used to generically refer to any type of physical device or
logical entity (such as an X.25 Virtual Circuit).
Terminal-Definition
Term ZLU in:p type poll select appl inst brnch work area
[callno] ”desc”
Pterm in:p type poll select [callno]
Option opt-word
Lterm ZLU type logical_address appl inst brnch work area
“desc”
Ldata location format data, data, ...
Repeat nnn
(Example from the “TTGEN Configuration File Example” at the end of
this section):
Term 0119 1:1 X25.SVC.IN 0000h 3200h 99 0 0 0 0 ”Level.3 SVC IN”
Term 0612 1:2 X25.LAPB 0209h 43EAh 10 0 0 0 0 ”Level.2 DCE”
option 37h
last_pvc 0
first_insvc 1
last_insvc 9
first_svc 0
last_svc 0
first_outsvc 0
last_outsvc 0
Term
Each terminal must be defined as a separate record commencing with
either the subheading “Term”, or the subheading “Pterm” with an
associated “Lterm” entry. The entries after the subheading are shown in
the following two examples.
Example for V Series or X Series Interface
Term ZLU in:p type poll select appl inst brnch work area
[callno] ”desc”